Fremar Pael

• Performed complex mechanical alignments and equipment calibration to meet quality standards.
• Organized work to meet demanding production goals.
• Maintained quality assurance and customer satisfaction objectives.
• Completed job reports and logs immediately following service calls.
• Maintained compliance with regulatory standards and safety requirements.
• Performed troubleshooting and diagnosis on malfunctioning equipment.
• Observed equipment operation to diagnose and troubleshoot reported issues.
• Addressed routine equipment maintenance according to established schedule.
• Inspected, evaluated and calibrated electrical and mechanical systems and components.
• Repair Car/Truck airconditioning system, Scanned and diagnosed Car/Truck ECU To identify the problem smoothly and easily
• Followed established procedures for inspection of belts, drives and motors, performing needed maintenance.
• Diagnosed and repaired problems with electrical and mechanical systems.
• Cleaned sheet metal ducts, evaporator coils, drip pans, axial and centrifugal fans and capacitor-start and resistance-start motors.
• Diagnosed faults in electrical and mechanical components to return units to full operating capacity within 24 hours of maintenance request.
• Installed, maintained, repaired, and tested equipment for electricity generation and utilization.
• Read and interpreted electrical, mechanical, and architectural drawings and electrical code specifications for wiring layouts.
• Used testing instruments such as ohmmeters, voltmeters, ammeters, and multimeters.
• Planned layout and installation of electrical wiring, equipment, and fixtures based on specifications and applicable code.
• Installed and wired electrical transformers, service panels, and circuit breakers.
• Performed routine and complex maintenance and repairs on various electrical equipment.
• Enhanced quality control by inspecting condition of equipment and tools.
• Replaced and repaired lighting fixtures and electrical control and distribution equipment.

• Completed job reports and logs immediately following service calls.
• Maintained quality assurance and customer satisfaction objectives.
• Organized work to meet demanding production goals.
• Addressed routine equipment maintenance according to established schedule.
• Suggested specialized fixtures, test equipment and procedures for failure analysis.
• Tested components and systems to evaluate performance and identify concerns.
• Performed troubleshooting and diagnosis on malfunctioning equipment.
• Maintained compliance with regulatory standards and safety requirements.
• Demonstrated to customers proper methods for operating equipment after it had been installed.
• Inspected, evaluated and calibrated electrical and mechanical systems and components.
• Maintained strong focus on safety and efficiency to provide comprehensive support to personnel performing skilled repairs.

DB termination,cable pulling,HVSG,MVSG,LVSG, VFD,OF,IF Installation and termination.

Motor control termination,meggering of power and control cables and measuring earth resistance.

Prepare quality control check sheets for each equipment

Building wiring,Db termination performed reading electrical blue prints drawing plan for cable trays,lighting fixture,convenience outlet,and wirings

• Demonstrated expertise in use of cable reels, stripping tools, voltage detectors, and wire and cable cutters to complete fast-paced work.
• Coordinated with other trades and general contractors to facilitate layout of recessed fixtures and architectural lighting.
• Inspected electrical systems, equipment and components to identify hazards, defects, and repair requirements.
• Installed and wired electrical transformers, service panels, and circuit breakers.
• Examined electrical units for loose connections and broken insulation.

Automotive wiring and troubleshooting

Car/truck aircon repair and troubleshooting